Skip to content
Open sponsorship. Site bar + newsletter spot, US$50/week.
GENERATORCODES

Home / Honeywell / 1100

Sync 2.0 / 3.0 (Evolution e-codes)

1100

Overcrank

Fuel · Alarm

The Gentek Evolution guide, which it says also covers Honeywell Sync 2.0/3.0, describes 1100 as the controller commanding a start, confirming that the engine is cranking, and not getting a start. It calls the usual cause fuel or maintenance, and says to confirm the fuel supply is on and, on LP, that the tank is not empty.

Seen on: Honeywell Sync 2.0 and 3.0 home standby controllers. Gentek's Evolution fault guide says this e-code list applies to those Sync controllers because they use the Generac Evolution control.

Likely causes

  • Fuel supply off.
  • Empty LP tank.
  • Maintenance items that keep a cranking engine from firing.

Checks an owner can do

  1. Turn the fuel supply on.
  2. On LP, confirm the tank is not empty.
  3. Do not keep cranking after the controller has locked out.

When to call a pro

If fuel is available and 1100 remains, the guide points at maintenance items a technician should take from there.

Source

Gentek Power Generac Evolution 1.0/2.0 fault guide (November 2018), which states the same e-code list applies to Honeywell Sync 2.0/3.0. Meanings below are limited to rows quoted from that guide.

Wording follows that document. Firmware can change a threshold. If this page and the manual shipped with your unit disagree, follow the manual.

What fixed mine

No approved reports for this code yet. Send one. It stays in the review queue until it is approved.

https://generatorcodes.com/brand/honeywell/1100